Pentax ZX-M - Data Back: Adjusting Hour and Minute

Adjusting the hour / minute
1. Press O the DATE button repeatedly until the
time is displayed.
2. Press O the SELECT button to make the
hour, minute or second ( : ) you want to
change blink. The digits blink in the following
order.
Hour - Minute - : - Hour
3. Change the data (hour or minute) with O the
ADJUST button . The digits increases one
each time you press the ADJUST button.
Holding the button for 2 to 3 seconds will
change the digits continuously.
4. To change the second ( : ), press O the
SELECT button until " : " blinks, and then
press the ADJUST button in sync with a time
signal to set the second to zero.
5. Press O the SELECT button to stop the
adjusted hour / minute from blinking.
Operating precautions
• The working temperature for data printing is O^C-
SO^C {32°F - 122°F).
• Use DX-coded films with ISO rating from 25 -
1600.
• If high-speed film with an ISO rating of 1000 or
faster is used, the imprinted characters may blur.
• If film with ISO rating of 50 or slower is used, the
printed characters may be dark or dim.
• If you release the shutter while the blinking data is
being corrected, the data cannot be imprinted.
ADVANCED
OPERATIONS