peplink balance ONE

To Next Page

To Previous Page

USER MANUAL

Peplink Balance Series

6.14.3 Rear Panel Appearance

Connector Ports

Power Connector

AC input 100-240V

Switches

Power Switch

Pressing and holding the key for 4 seconds will power down the unit.

When the unit is powered off, pressing this switch will power on the unit.

Power

Switch

Power

Connector

Main Page

Default Chapter1
- User Manual1
- Table of Contents2
1 Introduction and Scope7
2 Glossary8
3 Product Comparison Chart9
- Capacity9
- Core Functionality10
- VPN Functionality11
- WLAN Control12
- Advanced Qos13
- Networking Functionality14
- Device16
- Hardware18
4 Product Features19
- Supported Network Features19
- Wan19
- Lan19
- Vpn19
- Inbound Traffic Management20
- Outbound Policy20
- AP Controller20
- Qos20
- Firewall20
- Captive Portal21
- Other Supported Features21
5 Package Contents22
- Peplink Balance One22
- Peplink Balance 20/30/30 LTE/5022
- Peplink Balance 210/31022
- Peplink Balance 305/380/580/710/1350/250022
- Peplink Mediafast 20022
- Peplink Mediafast 50022
6 Peplink Balance Overview23
- Peplink Balance One23
- Peplink Balance 2025
- Peplink Balance 3027
- Peplink Balance 30 LTE29
- Peplink Balance 5031
- Peplink Balance 21033
- Peplink Balance 31035
- Peplink Balance 30537
- Peplink Balance 38040
- Peplink Balance 58043
- Peplink Balance 71046
- Peplink Balance 135049
- Peplink Balance 250052
- Console Port53
- Peplink Mediafast 50056
7 Installation59
- Preparation59
- Constructing the Network59
- Configuring the Network Environment61
8 Basic Configuration62
- Connecting to the Web Admin Interface62
- Configuration with the Setup Wizard63
- Advanced Setup67
- Cellular WAN68
- Network Mode69
9 Mediafast Configuration74
- Setting up Mediafast Content Caching74
- Scheduling Content Prefetching75
- Clear Statistics76
- MDM Settings77
- Viewing Mediafast Statistics78
10 Configuring the Lan Interface(S)79
- Static Route83
- Dns Caching84
- LAN Configuration with VLAN86
11 Drop-In Mode91
12 Configuring the Wan Interface(S)94
- Physical Interface Settings96
- Connection Method(S)97
- WAN Health Check105
- Bandwidth Allowance Monitor108
- Additional Public IP Settings109
- Dynamic DNS Settings110
13 Pepvpn with Speedfusion Tm Bandwidth Bonding112
- Speedfusion TM Settings112
- Nat Mode114
- The Peplink Balance Behind a NAT Router118
- Speedfusion TM Status119
14 Ipsec Vpn120
- Ipsec VPN Settings120
- Ipsec Status123
15 Outbound Policy Management124
- Outbound Policy125
- Custom Rules for Outbound Policy126
16 Inbound Access134
- Definition of Servers on LAN134
- Definition of Port Forwarding135
- Inbound Access Services137
- Domain Name142
- Reverse Lookup Zones153
- DNS Record Import Wizard157
17 Nat Mappings161
18 Captive Portal163
- Ldap Server164
19 Qos166
- User Groups166
- Bandwidth Control167
- Application168
20 Firewall170
- Outbound and Inbound Firewall Rules170
- Event Logging173
21 Ospf & Ripv2177
22 Remote User Access180
Miscellaneous Settings182
- High Availability182
- Certificate Manager185
- Service Forwarding185
- Service Passthrough187
23 Ap ····························································································································189
- AP Controller189
- Wireless SSID190
- Profiles195
- Info199
- Usage200
- AP Status202
- Rogue AP204
- Toolbox204
24 System Settings205
- Admin Security205
- Front Panel207
- Firmware209
- Time210
- Email Notification211
- Event Log213
- Snmp214
- Incontrol216
- Configuration217
- Feature Add-Ons218
- Reboot218
25 Tools219
- Ping219
- Traceroute Test220
- CLI (Command Line Interface) Support220
26 Status222
- Device222
- System Time223
- Active Sessions224
- Client List226
- WINS Client226
- OSPF & Ripv2226
- Speedfusion TM Status227
- Event Log229
- Bandwidth231
Appendix A. Restoration of Factory Defaults236
Appendix B. Routing under Dhcp, Static Ip, and Pppoe237
- Routing Via Network Address Translation (NAT)237
- Routing Via IP Forwarding238
Appendix C. Case Studies239
- Performance Optimization239
- Maintaining the same IP Address Throughout a Session243
- Bypassing the Firewall to Access Hosts on LAN244
- Inbound Access Restriction245
- Outbound Access Restriction246
Appendix D. Troubleshooting247
Appendix E. Product Specifications249
- Peplink Balance 20, 30, 30 LTE, and 50249
- Peplink Balance 210 and 310250
- E.2 Peplink Balance 210 and 310250
- Peplink Balance 380251
- E.3 Peplink Balance 380251
- Peplink Balance 305252
- E.4 Peplink Balance 305252
- Peplink Balance 380253
- E.5 Peplink Balance 380253
- Peplink Balance 580254
- E.6 Peplink Balance 580254
- Peplink Balance 710255
- E.7 Peplink Balance 710255
- Peplink Balance 1350256
- Peplink Balance 2500257
- Peplink Mediafast 200/500258
- E.10 Peplink Mediafast 200/500258
Appendix F. Declaration259

peplink balance ONE - Page 58

Table of Contents

Related product manuals