peplink balance ONE - Page 72

USER MANUAL
Peplink Balance Series
http://www.peplink.com -72 / 261 - Copyright © 2015 Peplink
When Remain connected is chosen, setting this WAN connection as active will make it
immediately available for use.
Idle Disconnect
When Internet traffic is not detected within the user specified timeframe, the modem will
automatically disconnect. Once the traffic is resumed by the LAN host, the connection
will be reactivated.
Health Check Settings
Heath Check
Method
This setting allows you to specify the health check method for the cellular connection.
The available options are Disabled, Ping, DNS Lookup, HTTP, and SmartCheck.
The default method is DNS Lookup. See Section 0 for configuration details.
Timeout
If a health check test cannot be completed within the specified amount of time, the test
will be treated as failed.
Health Check
Interval
This is the time interval between each health check test.
Health Check
Retries
This is the number of consecutive check failures before treating a connection as down.
Recovery
Retries
This is the number of responses required after a health check failure before treating a
connection as up again.