EasyManua.ls Logo

Perel EFLC2 - Use; Operating Lighting Modes; Batteries; Battery Replacement Procedure

Perel EFLC2
23 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EFLC2
02 – 28/12/2012 4 ©Velleman nv
Damage caused by disregard of certain guidelines in this manual is not
covered by the warranty and the dealer will not accept responsibility for
any ensuing defects or problems.
4. Features
Settings: 3 white LEDs / 6 white LEDs / 1 yellow LED / off
bungee strap
5. Overview and use
Refer to the illustrations on page
2
of this manual.
1
lantern
4
battery holder
2
bungee strap
5
torch head
3
housing
6
mode button
6. Use
Refer to the illustrations on page
2
of this manual.
Make sure batteries are inserted. Refer to §7.
Press the mode button [6] to scroll through the different functional
modes:
First press: torch
Second press: bright white lantern
Third press: moderate yellow lantern
Fourth press: off
The bungee strap [2] can be used in two ways:
o [A]: to hang the lantern on a tent pole etc. …
o [B]: to carry as a torch.
7. Batteries
Replace the batteries when the light becomes dim.
Switch off the device [6] and unscrew the torch head [5] (counter
clockwise).
Gently pull the battery holder [4] from the housing [3].
Insert 3 new 1.5V AA batteries following the polarity as indicated inside
the battery compartment. Only use new batteries of the same type with
the same specifications.
Slide the battery holder [4] back into the housing [3]. It fits in only
one way; do not force.
Screw the torch head [5] back in place (clockwise).