Perel PHT700 - Page 10

PHT700/PHT1200
V. 02 – 28/05/2021 10 ©Velleman nv
5. Overview
Refer to the illustrations on page 2 of this manual.
1
heater knob
2
rotation knob
6. Operation
1. Install the appliance on a firm and level surface, free from obstructions and at least
1 m away from any wall or combustible materials.
2. Make sure the heater knob is in the off position (0). Insert the power plug into the
mains.
3. Turn the heater knob to either low or high mode, with or without oscillation (OSC).
350 W (PHT700)
600 W (PHT1200)
700 W (PHT700)
1200 W (PHT1200)
LOW + OSC
HIGH + OSC
This appliance allows selecting the
oscillation degree. Do so by turning the
rotation knob.
4. After use, turn the selector knob back to the off position (0) and disconnect the
appliance from the mains.
This heater is equipped with a safety tilt switch, which automatically switches off the
appliance if it is not in the upright position.