Perel SMART1310 User Manual

SMART1310
V. 01 – 07/06/2021 6 ©Velleman nv
5. Assembly
Fit the included feet to the unit before using the
appliance. These are to be attached to the base of the
heater using the four included self-tapping screws, taking
care to ensure that they are located correctly in the
bottom ends of the side mouldings.
6. Overview
Refer to the illustrations on page 2 of this manual.
Heater
1
air outlet
4
on-off switch
2
control panel
5
temperature sensor
3
handle
6
air inlet
Control Panel
1
selected heating level
9
running time
2
fan
10
selected temperature
3
frost protection
11
measured temperature
4
selected temperature unit
12
on-off button
5
fan button
13
IR eye
6
temperature increase
14
Wi-Fi button
7
temperature decrease
15
heat setting button
8
timer button
16
Wi-Fi LED
Remote Control
1
on-off
5
fan
2
Wi-Fi
6
temperature decrease
3
temperature increase
7
timer
4
heat setting
7. Use
Powering the Appliance
• Connect the appliance to the mains and switch it on. The current ambient temperature is
displayed.
• Select the heating mode (750 W/1250 W/2000 W + frost protection).
Setting the Temperature
• Set the desired temperature with the temperature increase/decrease button. The setting
range is 5 °C to 37 °C. The appliance will automatically enter the stand-by mode as soon
as the room temperature reaches the set temperature, and restart heating when the
ambient temperature drops 1 °C below the set temperature.
• In frost protection mode, an appliance in stand-by will automatically switch to the highest
heating mode (2000 W) as soon as the room temperature drops to 5 °C and switch off
when the ambient temperature reaches 9 °C.

Perel SMART1310 Specifications

General

Brand	Perel
Model	SMART1310
Category	Heater
Language	English