Perel VTBAL200 - Page 3

VTBAL200
V. 01 – 19/10/2018 3 ©Velleman nv
4. Operation
4.1 General Operation
Place the scale on a solid, level and non-slippery surface.
Pump the start button once with your foot. Please wait until the display shows 0.0.
The scale automatically switches off after one minute.
4.2 Remarks
 The factory default unit is kg. Set the desired weighing unit with the switch in the
back of the scale.
 Err appears on the display if the scale is overloaded.
 Low battery power. Reload by pumping the start button.
 Unit selection (please set unit before weighing).