Parts Included:
1 - Assembled Back
1 - Assembled Seat
1 - Set of Arms
1 - Set of Interlocking Cross Supports
1 - Swivel
2 - Arm Supports (left & right)
4 - Circular Lower Leg Supports/Footrests
4 - Lower Legs for Base
1 - Backboard
ASSEMBLY INSTRUCTIONS
Swivel Dining, Counter Height or Bar Height Chair
Tools Not Included but Required: 7/16" wrench, or socket & ratchet and a power drill
Tools Included: #2 Square Drive Bit, 4mm Allen Wrench
Stainless Steel Hardware Included:
8 - 3-1/2" Bolts
8 - 3" Bolts
2 - 2-1/2" Bolts
2 - 2-1/4" Hex Head Bolts
4 - 3" Lag Screws
4 - 4" Deck Screws
2 - 1-1/2" Lag Screws
5 - 2" Deck Screws
4 - 1-5/8" Deck Screws
22 - Flat Washers
14 - Lock Washers
14 - Nuts
6 - Lock Nuts
Step 1
1. Assembling the base. 1a:Take the set of interlocking cross supports and lock them together using a 2"
deck screw making sure the provided screw hole is facing up. 1b: Next take one of the four lower legs for
the base and attach one circular lower leg support using a 3" lag screw making sure to place the pocket of
the circular lower leg support towards the ground. Repeat for other 3 legs. 1c: Next, attach one lower leg
to the cross section you assembled in step 1a using a 4" deck screw. Then repeat with the 3 remaining legs.
Make sure to insert the circular support into each leg as you go. 1d: Next, ip the base over and nish
screwing the circular supports to each leg using the four 2" deck screws.
Assembled Seat
Circular Lower
Leg Supports
Arms
Cross
Supports
Arm Supports
Lower Legs
Swivel
Hardware
Assembled Back
1a
1d
1b
Backboard
2. Attach the swivel to the seat using two 2-1/4" hex head bolts &
washers and two 1-1/2 lag screws & washers. The lag screws should
go into the wider swivel support. The bolts should go through the
swivel mechanism rst and then through the supports under the seat.
Place a at washer and lock nut onto each bolt and tighten.
Step 2
NOTE: Swivel will loosen after some use.
1c
To Next Page
Need help?
General
