PERFECTWERKS UKEG NITRO - Cleaning Your Ukeg; After Each Use Cleaning; Thorough Cleaning Procedure

6
CLEANING YOUR UKEG
• Turn off gas.
• Remove cap and
rinse with warm
water.*
• Leave cartridge
installed for step 3.
1 . 3 .
• Discharge remaining
nitro gas by turning
dial and venting.
• Remove and recycle
gas cartridge.
4 .
• Fill with warm
water* and one
cleaning tablet.
• Cap and shake well.
• Baking soda is a
suitable substitute.
• Pressurize with
remaining nitro gas
and briefly flow
water through tap.
• Let sit 10 minutes.
• Open tap until
pressure runs out.
• Remove cap, rinse all
parts with water.
• Remove the nozzle
for cleaning and
drying.
• Rinse (make sure
parts inside nozzle
remain intact).
• Allow to dry
by pouring out
remaining water.
• Store with cap off
and tap open in dry
place.
5 .
uKeg Cleaning Tablets
Available at:
www.perfectwerks.com
1 . 2 . 3 .
AFTER EACH USE
FOR A MORE THOROUGH CLEANING
• Fill with warm water*,
install cap, open tap.
• Use remaining nitro
gas to flow water
through tap.
• If no gas remains, fill
full with warm water
to flow through tap.
• Rinse uKeg with
warm water.*
• Repeat 2-3 times
until clean.
2 .
Nozzle
Straightener
Restrictor
Tap Housing
Filter
*120º F (49º C)
• To clean coffee
grounds from tap,
invert bottle, open
tap and flow water
backwards through
faucet.
4 .
4 .