UNPACKING AND INSPECTION
After opening the carton, unpack your new product and related parts and accessories. Please
inspect it carefully for any damage that may have occurred during transit. Please check it against
the photograph on carton. If any parts are missing, please call customer service at 1-800-426-1262
WARNING: DO NOT operate this product if damaged during shipment, handling or misuse.
Do not operate the product until the parts have been replaced or the fault rectified. Failure to do
so may result in serious personal injury or property damage. All damaged parts must be repaired
or replaced as needed prior to operating this product. Check to see that all nuts, bolts and fittings
are secure before putting this product into service.
If you have any questions, or require assistance with damaged or missing parts, please contact
our customer service department at 1-800-426-1262. Please have the serial number, model
number, and date of purchase available for reference when calling.
TOOLS REQUIRED
1. Phillips Screwdriver
2. 13 and 14 mm Sockets or Wrench
3. 5 mm Hex Key
1. Connect the two Support Frames (2) to the Tray (11) and Base Frame (8) assembly using the
four larger Bolts (10), Washers (6) and Nuts (5).
2. Place Reinforcement Bars (12) across Support Frames, aligning holes.
3. Attach the Seat Cushion (1) to the aligned Support Frames and Reinforcement Bars using
the four Screws (4) and Washers (3) provided.
4. Tighten all hardware before using.
5. Insert Wheel (9) into holes of Base Frame (8)
and insert Cap Screw (7) into holes on
Frame and Tray. Fasten nut.
6. Repeat step 5 on all four wheels.
WARNING: DO NOT STAND ON STOOL.
Not designed for use as a footstool, ladder, or
other support for placing your feet on, in any way.
Part # Description Qty.
1 Seat Pad 1
2 Side Frame 2
3 Washer 6 4
4 Seat Pad 4
5 Seat Pad 4
6 Seat Pad 4
7 Seat Pad 4
8 Seat Pad 1
9 Seat Pad 4
10 Seat Pad 4
11 Seat Pad 1
ASSEMBLY INSTRUCTIONS
1
2
3
4
5
6
7
8
9
10
11