ZZ502 Engine Torque Specications:
Distributor bolt/screw ...........................................18 ft.-lbs. / 25 N·m
Flywheel bolt/screw ..............................................65 ft.-lbs. / 90 N·m
Intake manifold bolt/screw
First pass ........................................................ 10 ft.-lbs. / 14 N·m
Second pass ................................................... 25 ft.-lbs. / 34 N·m
Oil level indicator tube bolt/screw ........................ 106 in.-lbs. / 12 N·m
Oil pan drain plug ................................................ 15 ft.-lbs. / 20 N·m
Spark plug ........................................................... 22 ft.-lbs. / 30 N·m
Starter motor bolt/screw ...................................... 35 ft.-lbs. / 48 N·m
Water pump bolt/screw ........................................ 30 ft.-lbs. / 40 N·m
Note: These torque values are in addition to those documented within the short and long block instructions.
FRONT
Information may vary with application. All specications listed are based on the latest production information available at
the time of printing.
Caution
This engine assembly needs to be lled with oil and primed. You should add the specied oil (see startup
instructions) to your new engine. Check the engine oil level on the dipstick and add accordingly.
To Next Page
Loading...