Need help?Do you have a question about the PerkinElmer 200 UV/VIS Series and is the answer not in the manual?
General| Wavelength Range | 190 - 1100 nm |
|---|---|
| Category | UV/VIS Spectrophotometer |
| Stray Light | < 0.05 %T at 220 nm (NaI) |
| Detector | Silicon Photodiode |
| Data Interval | 0.2, 0.5, 1.0, 2.0, 5.0 nm |
General electrical safety precautions and warnings related to the detector.
Ambient conditions required for optimal detector operation and performance.
Crucial warnings regarding the presence of high voltage within the detector.
Information on UV radiation hazards and necessary protective measures.
An overview of the Series 200 UV/VIS LC Detector and its capabilities.
Description of the main components of the Series 200 UV/VIS LC Detector.
Procedure for turning on and starting the detector for the first time.
Instructions on how to use the detector's keyboard and display interface.
Detailed technical specifications for the Series 200 UV/VIS LC Detector.
Guidelines for setting up the laboratory environment prior to detector installation.
Instructions for safely connecting the detector to the electrical power supply.
Procedures for making all necessary tubing connections for the detector.
Explanation of the manual operation mode and its characteristics.
Explanation of methods, their states, and management within the detector.
Introduction to sequences for automated method execution.
Overview of various detector configuration tasks and options.
Configuring lamp settings, wavelength ranges, and status.
Procedure for performing a check on the detector's wavelength calibration.
Procedures for routine and preventive maintenance to ensure optimal performance.
Procedures for flowcell flushing, removal, and cleaning.
Detailed procedure for safely removing and replacing the detector lamp.
Step-by-step approach for diagnosing and resolving detector issues.
Importance and methods for selecting optimal wavelengths for analysis.
How detector response time affects signal quality, noise, and peak resolution.
Steps to configure the detector for external control by Turbochrom software.
Setting up the detector for direct control by Turbochrom.
To Next Page