8.2 M225Ti, M215C and M185C Engines
The engine is supplied with connections to suit a Morse 33C cable. Figure 1 shows the position of the speed
selector lever on the injection pump, and the anchor for the cable outer sleeve.
Although an electric stop is tted as standard equipment, in some cases a mechanical stop mechanism may be
required. The injection pump is tted with a stop lever, identied in gure 1, which may be operated remotely if
required, using a piano wire type cable assembly.
Gearboxes supplied at the time that the engine is purchased will be tted with connections to suit the Morse
33C cables.
Speed
selector
lever
Idle
Full
speed
Stop
Run
Stop
lever
Anchor point
Morse 33C cable
(not supplied)
Figure 1 - Speed selector lever and stop lever.
To Next Page
Loading...
