TPD1317e Chapter 9
Page 61
Provision for Power Take-off
The ability to drive additional equipment from the crankshaft nose varies according to the engine model, as
shown in the table below:
Engine Models
Maximum PTO capability including both
axial and belt drives
Maximum belt drive power
M92/M115T
M130C/M135
Full engine power 6 kW
M185
59 kW at up to ............ 1000 rev/min
79 ................................. 1200
73 ................................. 1400
60 ................................. 1600
70 ................................. 1800
79 ................................. 2000
89 ................................. 2200
98 ................................. 2400
103 ............................... 2500
6 kW
M215C/M225Ti
Full power at up to ....... 1200 rev/min
80 kW .......................... 1400
62 ................................. 1600
62 ................................. 1800
84 ................................. 2000
93 ................................. 2200
104 ............................... 2400
110 ............................... 2500
6 kW
M265Ti 14 kW
8 kW at up to 2000 rev/min
5 kW above 2000 rev/min
M300Ti 8 kW at up to 1800 rev/min 8 kW at up to 1800 rev/min
Note: Above 1800 rev/min, no additional equipment should be driven by a M300Ti
Note: i) Maximum recommended offtake 2 kW per belt.
ii) Multiple belt driven accessories should as far as possible be distributed evenly on either side of the
engine to minimise side loads
iii) Customers wanting to t a non-standard drive pulley or coupling, should ensure the inertia of the
added components does not exceed 0.0313 kg/m
2
.
iv) If you are in any doubt, please contact your distributor.
To Next Page
Loading...
