Perkins M115T - 10 Calorifier and Block Heater Connections; Calorifier

TPD1317e Chapter 10
Page 63
Calorier and Block Heater Connections
10.1 Calorier
Fittings are available to allow a calorier to be connected to the engine, as shown in gure 1. The ttings may
be ordered as part of the engine assembly, or as loose parts to be tted later.
The hose connections to the calorier must be of a radiator or heater hose quality, and must be installed so
that chang will not occur.
Supply to
calorier
Front lifting eye
Return from
calorier
Connections are to
suit 1/2” bore hose
Figure 1a - Calorier ttings for 6 cylinder engines.
Figure 1b - Calorier ttings for M92 and M115T
Supply to
calorier
Return from
calorier