www.bringperlickhome.com
28
modulate from -3 F to +5 F. The refrigerator
controller can be adjusted through a range of
30 F to 42 F with an adjustable differential to
optimize storage conditions. The refrigerator
controller has been factory set to modulate from
37 F to 39 F. To properly determine product
temperature see “CHECKING PRODUCT
TEMPERATURE” on page 44.
IMPORTANT NOTE: ALWAYS ALLOW
CABINET TO RUN FOR A MINIMUM OF 24
HOURS TO ALLOW TEMPERATURE
STABILIZATION AFTER START-UP BEFORE
STORING PERISHABLE ITEMS.
IMPORTANT NOTE: PERLCK’S MULTI-ZONE
UNITS ARE NOT DESIGNED FOR OUTDOOR
APPLICATIONS. INSTALLING MULTI-ZONE
UNITS OUTDOORS WILL VOID THE
WARRANTY.
This cabinet is a frost-free model meaning the
evaporator (cooling coil) automatically defrosts
on demand at predetermined intervals. The
controller also has a manual defrost soft button
on the front panel signified by a melting
snowflake. If depressed it will automatically put
the system into a defrost cycle.
PROPER PRODUCT STORAGE
Store product as desired. Do not block internal
louvers or fan guard openings, as this will
decrease operating performance.
CONTROL SETTINGS
The cabinet is shipped with the controllers
turned ON. To turn the refrigeration system OFF
or ON press the blue soft button on the front
face of the freezer controller (if the controller is
turned off with power applied to the cabinet the
LED display will read OFF, when turned on it will
read a temperature). The freezer controller is on
the top front face of the cabinet above the left
door and is equipped with a tinted see-through
lens which opens by pulling out on the bottom of
the lens and rotating upwards. Always ensure
lens cover is closed before closing door to avoid
damage to the controller or lens. The refrigerator
control looks and responds identical to the
freezer control with the exception that it only
controls the cooling system for the refrigerator
zone and is located above the center door.
The freezer electronic control comes preset for a
product temperature of approximately 0 F with a
product temperature adjustability range of -5 F
to +5 F. The refrigerator electronic control
comes preset for a product temperature of
approximately 38 F with a product temperature
adjustability range of 33 F to 42 F. To change
temperature controller settings see section
“TEMPERATURE CONTROLLER
ADJUSTMENTS” on page 42.
IMPORTANT NOTE: THE LED DISPLAY IS
READING ACTUAL AIR TEMPERATURE NOT
PRODUCT TEMPERATURE. UNDER THESE
CONDITIONS, AN 8 F AIR TEMPERATURE
SWING IN THE FREEZER COMPARTMENT
AND A 2 F AIR TEMPERATURE SWING IN
THE REFRIGERATOR COMPARTMENT DOES
NOT CHANGE THE ACTUAL PRODUCT
TEMPERATURE. PRODUCT TEMPERATURE
REMAINS AT A VERY STABLE
TEMPERATURE.
LIGHT SWITCH AND BULB
Your Three-Door
Freezer/Refrigerator/Refrigerator has three
interior lights that are illuminated when each
respective door is opened. The cabinet also
comes standard with a manual light switches
located next to each light for displaying your
products through a glass door. If manual light
switch is left on for an extended period of time it
may increase the cabinet temperature,
especially in close proximity to the light at the
top and cause the refrigeration system to run
longer.
THREE DOOR
FREEZER/REFRIGERATOR/ WINE
COOLER OPERATION
The Perlick Three Door
Freezer/Refrigerator/Wine Cooler (H3FRW)
comes equipped with a state of the art
refrigeration system. The compressor is of a
variable speed variety, which automatically
changes speeds based on system conditions
and load. The cabinet is equipped with three
adjustable digital temperature controllers and
LED displays. The freezer controller can be
adjusted through a range of -10 F to +10 F.
The freezer controller has been factory set to
modulate from -3 F to +5 F. The refrigerator
controller can be adjusted through a range of
30 F to 42 F. The refrigerator controller has
To Next Page
Loading...
