What to do if there is no signal on the perma-tec Star Control Lubrication systems display?
If there's no signal on the display of your perma-tec Lubrication system, the cable might be damaged. Replace the cable to resolve this.
Why is the LED blinking red on my perma-tec Star Control Lubrication systems when the LC is not empty?
If the LED is flashing red and the LC is displayed even though the LC is not empty on your perma-tec Lubrication system, it indicates that too small an LC size is set. Select the correct LC size and replace the LC.
How to fix no lubrication in perma-tec Star Control?
If there is no lubrication from your perma-tec Lubrication system, rotate the threaded ring up to the mark, ensuring the arrow is completely visible.
What to do if LED flashes LC empty on perma-tec Star Control Lubrication systems?
If the LED is flashing and LC is displayed as empty on your perma-tec Lubrication system, it means the selected LC size is too large. To fix this, select the correct LC size and replace the LC.
General| Lubricant Volume | 60 cm³, 120 cm³, 250 cm³ |
|---|---|
| Drive | Electromechanical |
| Temperature range | -20 °C to +60 °C |
| Protection class | IP65 |
| Output Pressure | 5 bar |
| Operating Voltage | 4.5 V DC |
| Pump Type | Piston pump |
| Voltage | 4.5 - 36 V DC |
| Lubricant Capacity | 60 cm³ / 120 cm³ / 250 cm³ |
To Next Page