3
EN
Remove the plunger tip and mount one of the rubber
washer. Make sure of a firm and correct fit. The rubber
washer has to be stretched when fastened by up to
0.04 in.
Lube the rubber washer with the lubricant stored in
the respective container on one end of the plunger.
The head of the plunger must not be lubricated. Best
use the finger with which you will not touch the tinder
later. Place the plunger body over the plunger and
press down. If it bounces back up on its own accord,
the fire plunger closes airtight.
Take a small (pea-sized) piece of tinder from the con-
tainer and place it inside the lighting cavity. The tinder
must fit securely into place and may not protrude.
Place the plunger upright onto a stable mounting
surface and press the plunger body downwards.
Then directly remove it straight upwards once again.
Transfer the embers onto a previously prepared ball
of tinder and thus light your fireplace.
1
2
3
4
5
Handling
To Next Page
Loading...