Need help?Do you have a question about the Pfaff Industrial 3371-1/01 and is the answer not in the manual?
General| Type | Lockstitch Sewing Machine |
|---|---|
| Power Requirements | 220-240 V, 50/60 Hz |
| Motor Power | 550 W |
| Stitch Length | 6 mm |
| Stitch Type | Lockstitch |
General notes and guidelines for performing machine adjustments, including safety precautions.
List of necessary tools, gauges, and accessories required for accurate machine adjustments.
Explanation of common abbreviations and symbols used throughout the adjustment manual.
Setting the correct initial position of the sewing machine for operation.
Aligning the zero point of the work clamp drive unit for accurate positioning.
Adjusting the work clamp in X and Y directions to avoid needle collision during sewing.
Adjusting the hook driver for proper machine operation and to prevent binding.
Adjusting the needle bar to the specified height relative to the needle bar bush.
Setting the clearance between the hook and the needle at specific points.
Centering the hook point to the needle and adjusting the needle guard contact.
Centering the needle to the cutout and aligning the hook race cover.
Setting the correct height and parallelism of the work clamp relative to the needle plate.
Positioning the thread wiper correctly relative to the needle plate.
Adjusting the position of the control cam relative to the arm shaft and machine case.
Centering the control roller to the running path of the control cam.
Setting the thread trimmer drive shaft flush with the machine case edge.
Setting the clearance between the thread trimmer lever and the stop plate.
Positioning the trimmer solenoid at the specified distance from the machine case.
Setting the distance of the engaging lever pin from the release trip.
Positioning the thread catcher and knife blade relative to the needle hole and plate.
Ensuring the slots of the release trip touch the screws on the right side.
Setting the distance between the drive lever and pin when the release catch is engaged.
Setting the needle thread tension release distance after thread trimming.
Adjusting the thread check spring stroke and thread regulator position.
Adjusting the bobbin winder drive wheel distance and engagement.
Calibrating the work clamp initiator for correct detection of clamp position.
Steps for changing the work clamp and adjusting sewing area size.
Performing a cold start reset to revert machine settings to factory defaults.
Procedure for updating the machine software via the internet.
Detailed list of machine parameters, their descriptions, and setting ranges.
Explanations for various error codes displayed on the control panel.
Details on common errors related to the sewing motor operation.
Details on errors related to the OTE (Sewing head recognition unit).
Reference list for components and connections used in the circuit diagrams.
To Next Page
