Need help?Do you have a question about the Phaetus Dragonfly BMO Hotend and is the answer not in the manual?
General| Type | Hotend |
|---|---|
| Temperature Range | up to 300°C |
| Filament Compatibility | PLA, ABS, PETG, TPU, Nylon, and more |
| Thermistor | NTC 100K |
| Heater Cartridge Voltage | 24V |
| Heater Cartridge Wattage | 40W |
| Nozzle Diameter | 0.4mm (compatible with various sizes) |
| Cooling | Active cooling with a fan |
| Compatibility | Ender 3, Ender 3 Pro, Ender 3 V2, Ender 5, Ender 5 Pro, CR-10, CR-10S |
| Nozzle Compatibility | V6 Nozzles |
| Material | Aluminum |
To Next Page
