Phanteks Magnium Gear NEO Qube 2 - Component Installation; Motherboard Installation; Power Supply Installation; Storage Installation

MAGNIUMGEAR
03
With all the panels removed, there is enough room to place all of
your components. We’ll first start with the motherboard.
The HDD brackets can be positioned as shown in option B and C
or removed to allow for 5x 2.5” SSDs as option A.
There are dierent configurations possible with the storage
bracket. Below you see the configuarations as, A, B or C. Use the
provided SSD and/or HDD screws.
After the drives have been installed, place back the storage
bracket onto the chassis and secure with 2x case screws.
Use the SSD screws to install the 2.5”
SSD’s. The 3.5” HDD can be installed with
the HDD screws.
Remove the storage bracket before installing the power supply.
The power supply is then secured with 4x PSU screws.
03
05
04
Supported Motherboad form-factors are:
Mini-ITX | Micro-ATX* | ATX | E-ATX (up to 280mm wide)
*For Micro-ATX Motherboards, please re-position the stand-os according to the
motherboards’ manual.
PSU
2.5”
3.5”
3.5”
B
A
C
2.5” 2.5” 2.5”
2.5”
2.5”
2.5”
2.5”
2.5”
2.5”
2.5”
SSD Screw HDD Screw
Case Screw
2x
REMOVE
PSU Screw
4x
INSTALL
Motherboard
Screw
9x
INSTALL
Case Screw
2x
INSTALL
MOTHERBOARD
STORAGE INSTALLATION
POWER SUPPLY