newborn buggy
(carry a newborn baby)
1. With buggy set up ready to go,
apply brakes.
2. Undo 2 clips at back of seat, ‘a’ and ‘b’.
ups
`
downs
a
b
3. Undo clips ‘c’ and ‘d’ at top of seat
base and push base corners down
until it is almost flat.
4.
Undo zips fully
on either side of
seat base for a
completely flat
newborn bed.
c
d
5. Lie baby flat in newborn position,
facing forward, and secure baby firmly
with adjusted safety harness.
WARNING: Never allow the plastic to fall over the child.
1
2
2
3
3
using the clear plastic back flap
1. Attach clear plastic back flap using
hook/loop tape at top, ‘1’, and sides, ‘2’
and ‘3’.
The back flap can be rolled up
and held at top using strip of
hook/loop tape at top.
98
To Next Page
