Philippe+Aglioni SimpleOne User Manual

e
rea
Automatic Soap Dispenser
USER MANUAL
AAA
AAA
AAA
AAA
Operational Instructions
1. Unscrew the cover from bottom of unit
2. Insert batteries and screw cover back on
Attention:
Please insert batteries according to the
diagram inside the lid for proper installation.
.
22 3m m
138m m
81mm
Specifications
Name Automatic Soap Dispenser
Model
Unit size 5.4”x 2.3”x 8.8”
Induction distance 0-3.5 Inches
Material PP
,
ABS
Vol 6.8 oz
Power supply 4 x AAA Batteries
①
②
3. To fill with soap, lift the top cover
4. Press the power button to Power On
5. Place your hand under the sensor area to
operate it
6. Blue light flashes repeatedly to indicate
low battery power
Infrared sensor
Infrared sensor zone
Recommendations
●
Use non-granular, non-foaming liquid
soap or hand sanitizer
●
Clean dispensing tip regularly and run
pump with warm water
③
④
⑤
⑥
Thank you for choosing the SimpleOne™ Automatic Soap Dispenser by PhillipeTaglioni.
Please read the Instruction Manual before using your new SimpleOne™ unit.
© 2014 ALL RIGHTS RESERVED XIUM LLC
Xium LLC, 333 Washington Blvd. Ste. 666, Marina Del Rey, CA 90292, USA
1-800-765-3628www.xiumhome.com

Philippe+Aglioni SimpleOne Specifications

General

Brand	Philippe+Aglioni
Model	SimpleOne
Category	Dispenser
Language	English

Summary

Specifications

Operational Instructions

Initial Setup

Unscrew bottom cover, insert batteries, and screw cover back on for initial setup.

Filling and Powering On

Lift top cover to fill with soap and press the power button to turn the unit on.

Operation and Low Battery Indicator

Place hand under sensor to operate; blue light flashes indicate low battery power.

Recommendations

Soap and Sanitizer Use

Use non-granular, non-foaming liquid soap or hand sanitizer for best results.

Maintenance

Clean the dispensing tip regularly and run the pump with warm water for upkeep.