Product Manual
© Philips Ledalite 2011Page 2
AIRWAVE PROGRAMMING GUIDE
15.0 Linking/Unlinking an Airwave Switch or Photosensor to a Transceiver
15.1 Linking using push buttons on the Airwave Transceiver
15.1.1 To Link an Airwave Switch
15.1.2 To Link an Airwave Photosensor
15.2 Linking Wirelessly
15.2.1 Linking using an Airwave wireless Switch to a new or cleared Transceiver
15.2.2 Linking an additional Airwave Wireless Switch to a Transceiver
15.3 Unlinking Devices
16.0 Linking/Unlinking an Occupancy Sensor to a Transceiver
16.1 Linking Wired 24Vdc Occupancy Sensors
16.2 Unlinking Wired 24Vdc Occupancy Sensors
16.3 Linking Wireless Occupancy Sensors
16.4 Unlinking Wireless Occupancy Sensors
17.0 Clearing Devices from a Transceiver
17.1 Clearing using Push Buttons on the Airwave Transceiver
17.2 Clearing using an Airwave Wireless Switch only
18.0 Understanding LED Blink Patterns
19.0 Transceiver Configuration Instructions
19.1 Understanding and Navigating in Configuration Mode
19.2 Steps to Enter Configuration Mode
19.3 Steps to Exit Configuration Mode/Menu
20.0 Configuration Mode – Detailed Instructions
20.1 Blink Code 1: Timeout Settings Table
20.2 Blink Code 2: Photosensor Set Point
20.2.1 For dimming ballasts
20.2.2 For non-dimming ballasts
20.3 Blink Code 3: Walk Test Mode
20.4 Blink Code 4: Link Mode
20.5 Blink Code 5: Repeater ON/OFF Mode
20.6 Blink Code 6: Occupancy Mode
20.7 Blink Code 7: Clear Mode
20.7.1 Clearing configuration Switch only
20.7.2 Clearing all devices:
20.8 Blink Code 8: Occupancy Transmit
20.8.1 Configuration Mode Method
20.8.2 Transceiver Push Button Method
20.9 Blink Codes 9-12: Demand Response
20.9.1 Blink Code 9: Enabling Demand Response
20.9.2 Blink Codes 10-12: Adjusting Demand Response Levels
Appendix A – Programming Quick Reference Guide
Appendix B - Layout and Wiring Diagrams
Appendix C – FAQs
To Next Page
Loading...