6) To adjust the trapezoid, press the or button.
7) When the trapezoid is adjusted, press the
button to confirm. Then to highlight
PARALLELOGRAM, press
to confirm.
8) To adjust the parallelogram, highlight parallelogram then to confirm. Press the or
button to adjust..
9) When the parallelogram is adjusted, press the
button to confirm. Press again to return to
the ADJUST SHAPE window. BACK TO MAIN WINDOWS will be highlighted.
10) Press the
button to return to the MAIN CONTROLS window, or press the button until
file:///D|/EDFU/crt_17_5/edoc/ENGLISH/OSD_2/osd_cont.htm (13 of 24)7/15/2004 5:33:25 PM
To Next Page
Loading...
