3) Press the button. The ADJUST SHAPE window appears. ADJUST SIDE CURVE should be
highlighted.
4) Press the button to highlight ADJUST SIDE ANGLES.
5) Press the
button. The SIDE ANGLES window appears. TRAPEZOID should be highlighted.
6) To adjust the trapezoid, press the or button.
7) When the trapezoid is adjusted, press the
button to highlight PARALLELOGRAM or press
the
button to return to the ADJUST SHAPE window.
file:///D|/EDFU/crt_19/edoc/english/OSD/osd_cont.htm (15 of 27)7/19/2004 4:08:26 PM
To Next Page
Loading...
