4-1 PL10.0DC
CABINET DISASSEMBLY INSTRUCTIONS
1. Disassembly Flowchart
This flowchart indicates the disassembly steps for the
cabinet parts and the CBA in order to gain access to
items to be serviced. When reassembling, follow the
steps in reverse order. Bend, route and dress the
cables as they were.
2. Disassembly Method
*1
: 19PFL3505D/F7 (Serial No.: DS1A)
Note:
(1) Order of steps in procedure. When reassembling,
follow the steps in reverse order. These numbers
are also used as the Identification (location) No. of
parts in figures.
(2) Parts to be removed or installed.
(3) Fig. No. showing procedure of part location
(4) Identification of parts to be removed, unhooked,
unlocked, released, unplugged, unclamped, or
desoldered.
P = Spring, L = Locking Tab, S = Screw,
H = Hex Screw, CN = Connector
e.g. 2(S-2) = two Screws of (S-2),
2(L-2) = two Locking Tabs of (L-2)
(5) Refer to the following "Reference Notes in the
Table."
Step/
Loc.
No.
Part
Fig.
No.
Removal Note
[1]
Stand
Assembly
D1 4(S-1) ---
[2]
Rear
Assembly
D1 9(S-2), (S-3) ---
[3]
Jack
Holder(D)
D2 (S-4) ---
[4]
Digital Main
CBA Unit
D2
D3
4(S-5), 4(S-6), 2(H-1),
CN3701, CN3702,
CN3902, Shield Box
---
[5]
Jack
Holder(A)
D2 (S-7) ---
[6] Jack CBA
D2
D3
4(S-8), CN701, CN871 ---
[1] Stand
Assembly
[2] Rear
Assembly
[13] IR Sensor
CBA
[3] Jack Holder
(D)
[7] Main CBA
[10] Speaker
Holder
[6] Jack CBA
[11] Speaker
[8] Stand Holder
[4] Digital Main
CBA Unit
[12] Function
CBA
[9] LCD Module
Assembly
[15] Front
Cabinet
[5] Jack Holder
(A)
[14]*
1
Junction
CBA
[7] Main CBA
D2
D3
11(S-9), CN102,
CN201, CN872,
CN1001, CN1002
---
[8]
Stand
Holder
D2 2(S-10), 2(S-11) ---
[9]
LCD
Module
Assembly
D2 --------------- ---
[10]
Speaker
Holder
D2 3(S-12) ---
[11] Speaker D2
4(S-13), Speaker
Cushion
---
[12]
Function
CBA
D2
D3
CL103B ---
[13]
IR Sensor
CBA
D2
D3
(S-14), CL102A
*1
---
[14]
*1
Junction
CBA
D2
D3
--------------- ---
[15]
Front
Cabinet
D2 --------------- ---
↓
(1)
↓
(2)
↓
(3)
↓
(4)
↓
(5)
Step/
Loc.
No.
Part
Fig.
No.
Removal Note
To Next Page
Loading...
