Mechanical Instructions
EN 9VEM1.1E_LA 4.
2013-Oct-18
back to
div. table
4. Mechanical Instructions
Index of this chapter:
4.1
Cable Dressing
4.2 Service Positions
4.3 Assembly/Panel Removal
4.4 Set Re-assembly
Notes:
• Figures below can deviate slightly from the actual situation,
due to the different set executions.
4.1 Cable Dressing
Figure 4-1 Cable dressing ( 22" 2000 series)
4.2 Service Positions
For easy servicing of a TV set, the set should be put face down
on a soft flat surface, foam buffers or other specific workshop
tools. Ensure that a stable situation is created to perform
measurements and alignments. When using foam bars take
care that these always support the cabinet and never only the
display. Caution: Failure to follow these guidelines can
seriously damage the display!
Ensure that ESD safe measures are taken.
4.3 Assembly/Panel Removal
Instructions below apply to the 32PFL3606H/12, but will be
similar for other models.
4.3.1 Rear Cover (22")
Refer to Figure 4-3
for details.
Warning: Disconnect the mains power cord before removing
the rear cover.
1. Remove the screw [1] that secures the power cable.
2. Remove the screws [2] that fixate the stand and remove
the stand.
3. At the indicated areas [Blue point] the cover is secured by
clips. Be careful with releasing those.
4. Lift the rear cover from the TV.
Figure 4-2 VESA bolts removal
19560_101_130826eps
130826
19421_100_1
30514.eps
130514
× 4
To Next Page
Loading...
