15
4. USB docking display introduction
3. Click “Install”, then DisplayLink start
to install, once it complete, click
“Finish”
4. After the installation has completed,
your laptop will be required to
reboot in order to start using the
USB docking display.
To verify the installation, check
to the Display adapters from your
system, the name of the monitor
will be shown, it means the
DisplayLink software installation is
successful.
2
Controlling the display
After the DisplayLink software is
installed completely, an icon appears in
the taskbar. This gives you access to the
DisplayLink manager menu.
To Next Page
Loading...
