Philips 3000i Series Manual

Maintenance
2
1
NanoProtect lter Series 3 (FY3430/30)
Mars DI HK/UK_EN
90x127mm
When display shows
When display shows
Time to clean the NanoProtect lter Series 3
Time to replace the NanoProtect
lter Series 3
Press to check lter lifetime status.
!
Press for 3 seconds to reset after cleaning or replacing lter.
3000 043 53022-1
The lter may produce smell after being used for a while because of the
absorption of indoor air. Remove the lter and place it where it has direct
sunlight and ventilation for several hours. Re-install and try using it again.
If the odor remains, please replace the lter.
Connectivity
Auto mode
Display
Control
Turbo mode Sleep mode
PM2.5
indicator
Air quality
light
Indoor allergen
index
Gas
indicator
Good Poor Very poorFair
Allergen index
1-12, 1 indicates
best air quality
Gas index
from L1-L4,
L1 indicates
best air quality
Filter cleaning
alert
Filter replacement
alert
Wi-Fi
indicator
2
Power Light
on/o
Display
switch
Mode
switch
Auto
Turbo
Sleep
IAI
PM2.5
Gas
3-digit display
IAI /
Gas / PM2.5
Filter status/
reset
Clean Home+
Open the app and click on "Connect a New Device" or press
the "+" button to connect your device. Please follow the steps
in the app.
You can use the app to control the purier and check air quality.
Download and install the Philips app
All manuals and user guides at all-guides.com
all-guides.com

Philips 3000i Series Specifications

General

Model	3000i Series
Room size	Up to 104 m²
Filters out viruses	Yes
Connectivity	Wi-Fi, App control
Filtration	HEPA, Active Carbon
Ultra fine particle filtration	Down to 0.003 microns
Air quality sensor(s)	PM2.5
Power consumption	60 W
Cord length	1.8 meters
Dimensions	290 x 290 x 645 mm