)-0/24!.4 3!&%49 ).3425#4)/.3
2EAD BEFORE OPERATING EQUIPMENT
2EAD THESE INSTRUCTIONS
+EEP THESE INSTRUCTIONS
(EED ALL WARNINGS
&OLLOW ALL INSTRUCTIONS
$O NOT USE THIS APPARATUS NEAR WATER
#LEAN ONLY WITH A DRY CLOTH
$O NOT BLOCK ANY OF THE VENTILATION OPENINGS )NSTALL IN ACCORDANCE WITH
THE MANUFACTURERS INSTRUCTIONS
$O NOT INSTALL NEAR ANY HEAT SOURCES SUCH AS RADIATORS HEAT REGISTERS
STOVES OR OTHER APPARATUS INCLUDING AMPLIâERS THAT PRODUCE HEAT
$O NOT DEFEAT THE SAFETY PURPOSE OF THE POLARIZED OR GROUNDINGTYPE PLUG
! POLARIZED PLUG HAS TWO BLADES WITH ONE WIDER THAN THE OTHER !
GROUNDING TYPE PLUG HAS TWO BLADES AND THIRD GROUNDING PRONG 4HE WIDE
BLADE OR THIRD PRONG ARE PROVIDED FOR YOUR SAFETY 7HEN THE PROVIDED
PLUG DOES NOT âT INTO YOUR OUTLET CONSULT AN ELECTRICIAN FOR REPLACEMENT
OF THE OBSOLETE OUTLET
0ROTECT THE POWER CORD FROM BEING WALKED ON OR PINCHED PARTICULARLY AT
PLUGS CONVENIENCE RECEPTACLES AND THE POINT WHERE THEY EXIT FROM THE
APPARATUS
/NLY USE ATTACHMENTSACCESSORIES SPECIâED BY THE MANUFACTURER
5SE ONLY WITH A CART STAND TRIPOD BRACKET OR TABLE SPECIâED BY
THE MANUFACTURER OR SOLD WITH THE APPARATUS 7HEN A CART IS
USED USE CAUTION WHEN MOVING THE CARTAPPARATUS COMBINATION
TO AVOID INJURY FROM TIPOVER
5NPLUG THIS APPARATUS DURING LIGHTNING STORMS OR WHEN UNUSED FOR LONG
PERIODS OF TIME
2EFER ALL SERVICING TO QUALIâED SERVICE PERSONNEL 3ERVICING IS REQUIRED
WHEN THE APPARATUS HAS BEEN DAMAGED IN ANY WAY SUCH AS POWERSUPPLY
CORD OR PLUG IS DAMAGED LIQUID HAS BEEN SPILLED OR OBJECTS HAVE FALLEN
INTO APPARATUS THE APPARATUS HAS BEEN EXPOSED TO RAIN OR MOISTURE
DOES NOT OPERATE NORMALLY OR HAS BEEN DROPPED
4HIS PRODUCT MAY CONTAIN LEAD OR MERCURY $ISPOSAL OF THESE MATERIALS
MAY BE REGULATED DUE TO ENVIRONMENTAL CONSIDERATIONS &OR DISPOSAL OR
RECYCLING INFORMATION PLEASE CONTACT YOUR LOCAL AUTHORITIES OR THE
%LECTRONIC )NDUSTRIES !LLIANCEWWWEIAEORG
$AMAGE 2EQUIRING 3ERVICE 4HE APPLIANCE SHOULD BE SERVICED BY
QUALIâED SERVICE PERSONNEL WHEN
! 4HE POWER SUPPLY CORD OR THE PLUG HAS BEEN DAMAGED OR
" /BJECTS HAVE FALLEN OR LIQUID HAS BEEN SPILLED INTO THE APPLIANCE OR
# 4HE APPLIANCE HAS BEEN EXPOSED TO RAIN OR
$ 4HE APPLIANCE DOES NOT APPEAR TO OPERATE NORMALLY OR EXHIBITS A
MARKED
CHANGE IN PERFORMANCE OR
% 4HE APPLIANCE HAS BEEN DROPPED OR THE ENCLOSURE DAMAGED
4ILT3TABILITY !LL TELEVISIONS MUST COMPLY WITH RECOMMENDED
INTERNATIONAL GLOBAL SAFETY STANDARDS FOR TILT AND STABILITY PROPERTIES OF ITS
CABINETS DESIGN
Ù $O NOT COMPROMISE THESE DESIGN STANDARDS BY APPLYING EXCESSIVE PULL
FORCE TO THE FRONT OR TOP OF THE CABINET WHICH COULD ULTIMATELY
OVERTURN THE PRODUCT
Ù !LSODO NOT ENDANGER YOURSELF OR CHILDREN BY PLACING ELECTRONIC
EQUIPMENTTOYS ON THE TOP OF THE CABINET 3UCH ITEMS COULD
UNSUSPECTINGLY FALL FROM THE TOP OF THE SET AND CAUSE PRODUCT DAMAGE
ANDOR PERSONAL INJURY
7ALL OR #EILING -OUNTING 4HE APPLIANCE SHOULD BE MOUNTED TO A
WALL OR CEILING ONLY AS RECOMMENDED BY THE MANUFACTURER
0OWER ,INES !N OUTDOOR ANTENNA SHOULD BE LOCATED AWAY FROM
POWER LINES
/UTDOOR !NTENNA 'ROUNDING )F AN OUTSIDE ANTENNA IS CONNECTED TO
THE RECEIVER BE SURE THE ANTENNA SYSTEM IS GROUNDED SO AS TO PROVIDE
SOME PROTECTION AGAINST VOLTAGE SURGES AND BUILT UP STATIC CHARGES
3ECTION OF THE .ATIONAL %LECTRIC #ODE !.3).&0! .O
PROVIDES INFORMATION WITH RESPECT TO PROPER GROUNDING OF THE MATS AND
SUPPORTING STRUCTURE GROUNDING OF THE LEADIN WIRE TO AN ANTENNA
DISCHARGE UNIT SIZE OF GROUNDING CONNECTORS LOCATION OF ANTENNA
DISCHARGE UNIT CONNECTION TO GROUNDING ELECTRODES AND REQUIREMENTS FOR
THE GROUNDING ELECTRODE 3EE &IGURE BELOW
/BJECTS AND ,IQUID %NTRY #ARE SHOULD BE TAKEN SO THAT OBJECTS DO
NOT FALL AND LIQUIDS ARE NOT SPILLED INTO THE ENCLOSURE THROUGH OPENINGS
A 7ARNING 4O REDUCE THE RISK OF âRE OR ELECTRIC SHOCK THIS APPARATUS
SHOULD NOT BE EXPOSED TO RAIN OR MOISTURE AND OBJECTS âLLED WITH
LIQUIDS SUCH AS VASES SHOULD NOT BE PLACED ON THIS APPARATUS
"ATTERY 5SAGE #!54)/. 4O PREVENT BATTERY LEAKAGE THAT MAY
RESULT IN BODILY INJURY PROPERTY DAMAGE OR DAMAGE TO THE UNIT
Ù )NSTALL ALL BATTERIES CORRECTLY WITH AND ALIGNMENT AS MARKED ON THE
UNIT
Ù $O NOT MIX BATTERIES OLD AND NEW OR CARBON AND ALKALINE ETC
Ù 2EMOVE BATTERIES WHEN THE UNIT IS NOT USED FOR A LONG TIME
%8!-0,% /& !.4%..! '2/5.$).' !3 0%2
.!4)/.!, %,%#42)#!, #/$% .%#
'2/5.$ #,!-0
!.4%..! ,%!$ ). 7)2%
!.4%..! $)3#(!2'% 5.)4
.%# 3%#4)/.
'2/5.$).' #/.$5#4/23
.%# 3%#4)/.
'2/5.$ #,!-03
0/7%2 3%26)#% '2/5.$).'
%,%#42/$% 3934%-
.%# !24 0!24 (
%,%#42)# 3%26)#% %15)0-%.4
.OTE TO THE #!46 SYSTEM INSTALLER THIS REMINDER IS PROVIDED TO CALL THE #!46 SYSTEM INSTALLERÒS ATTENTION TO !RTICLE OF
THE .%# THAT PROVIDES GUIDELINES FOR PROPER GROUNDING AND IN PARTICULAR SPECIâES THAT THE CABLE GROUND SHALL BE CONNECTED TO THE
GROUNDING SYSTEM OF THE BUILDING AS CLOSE TO THE POINT OF CABLE ENTRY AS PRACTICAL
To Next Page
Loading...
