Philips 32PFL3453/F7 A - Advanced Picture and System Settings; Over Scan and Source Label Customization; Other Settings and Factory Reset; Re-running the Setup Wizard

Over Scan
1
Use H I to select Over Scan, then use J K to select the
item.
Off To set Over Scan to Off
On To set Over Scan to On
Source Label
Create labels for the devices connected to your TV.
1
Use H I to select Source Label, then press OK.
2
Use H I
to select the source and use J K to select Default/
Antenna/Cable/Satellite/DTV/DVD/Blu-ray/HD-DVD/
XBOX/Wii/PS3/Game/Computer/VCR/DV/Custom.
Source Label
TV
AV
HDMI1
HDMI2
MULTIMEDIA
Default
Default
Default
Default
Default
Move
Select
Adjust
Back
Other Settings
Set the parameter of audio only, no signal power off, and no
operation power off.
1
Use H I to select Other Settings, then press OK.
2
Adjust the following items.
Audio Only
Play the audio with the picture turned off.
Off To set Audio Only to Off
On
When you turn the Audio
Only on and exit
the OSD menu, the panel will be dark and
then press any key to exit the Audio Only
status.
Restore Default
Change power on options or reset TV to factory default.
1
Use H I to select Restore Default, then press OK.
2
Use J K to select Yes, then press OK.
Setup Wizard
Set the first time installation.
1
Use H I to select Setup Wizard, then press OK.
●
Only at TV source, the selection is displayed.
●
For detail please refer to Setup Wizard L p. 15.
30 .English
Continued on next page.
Back to Contents