EasyManua.ls Logo

Philips 40PFL9705H/12 - IR & LED Board; Assembly;Panel Removal Monet Styling

Philips 40PFL9705H/12
432 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Mechanical Instructions
EN 19Q551.1E LA 4.
2010-Oct-01
back to
div. table
4.6.8 IR & LED Board
Refer to and Figure 4-10
for details.
Figure 4-10 IR & LED board
The IR/LED board is placed inside the LCD panel.
1. Remove the LCD panel as described earlier.
2. Unplug the IR/LED connector [1] from the backside.
3. Locate the bottom rim inside the LCD panel and remove all
six screws that secure it.
4. Take the rim out of the panel.
5. Remove the clipped on IR/LED board cover [2].
6. Shift the IR/LED board downwards out of it clamps
When defective, replace the whole unit.
4.7 Assembly/Panel Removal Monet Styling
(8000-series)
The instructions apply to the 37PFL8605K/02.
4.7.1 Rear Cover
Warning: Disconnect the mains power cord before you remove
the rear cover.
1. Remove the stand.
2. Remove all screws of the rear cover.
3. Lift the rear cover from the TV. Make sure that wires and
flat coils are not damaged while lifting the rear cover from
the set.
4.7.2 Speakers
Tweeters
Each tweeter unit is mounted with two screws.
When defective, replace the whole unit.
Subwoofer
The central subwoofer is located in the centre of the set and is
secured by two bosses.
When defective, replace the whole unit.
4.7.3 Mains Switch
The mains switch is mounted in the “leading edge” assembly.
Refer to the exploded view in Chapter 11.
4.7.4 Main Power Supply
Refer to Figure 4-11
for details.
Figure 4-11 Main Power Supply
1. Unplug all connectors [1].
2. Remove the fixation screws [2].
3. Take the board out.
When defective, replace the whole unit.
4.7.5 Small Signal Board (SSB)
Refer to Figure 4-12
for details.
Figure 4-12 SSB
1. Unplug all connectors [1].
2. Remove the fixation screws [2].
3. Slide the side cover sidewards [3].
4. Remove the screws [4].
5. Remove the bottom cover downwards [5].
4.7.6 Ambilight Units
Refer to Figure 4-13
for details.
Note: the Ambilight units are to be swapped on PWB level.
18754_106_100923.eps
100923
1
2
3
18750_102_100414.eps
100414
2
2
2
2
2
2
1
1
18750_103_100414.eps
100414
1 1
4
3
3
5
3
3
3
5
2
2

Table of Contents

Related product manuals