EN
54
Symptom Possible cause/Remedy
The remote does <
Verify if the remote is set correctly for the equipment your are using.
not function < Verify if the batteries are not dead. Replace the batteries.
You can still use the keys at the left side of the TV.
< Select TV mode on your remote control.
< When pressing a key and some key leds are blinking with a higher speed and
lower intensity than in a normal working condition, and your TV does not react on
the key press, remove the batteries out of the remote control and put them back
again.
The remote of < The infrared signals of the screen may influence the reception sensibility
connected equip- of other peripherals.
ment does not Solution: replace the batteries of the remote of other peripheral
function well equipment.
No photo or music < Verify if the source complies with a supported code.
play or in poor
quality
No stable or not < Verify if you have selected the correct VGA mode in your PC.
synchronised VGA See Connect a PC, p. 53.
picture < Verify the connections between the TV and the PC.
No solution found < Switch off your TV off and then on again once.
for your picture or Never attempt to repair a defective TV yourself.
sound problem Verify with your dealer or call a TV technician.
Red blinking led < Unplug the mains cord for 10 seconds and insert it in again.
Black bars with < Select another picture format.
HD channels
No EPG data <
The Electronic Programme Guide function and background programme
available
information are only made available by TV channels that provide EPG
information and in countries which support EPG.
See www.philips.com/support.
Troubleshooting (Continued)
To Next Page
Loading...
