Philips 42PFL5422/96 - Basic Operations; Power on and Standby; Turning the Display on; Putting the Display to Standby

Basic operations8
English
Basic operations
Power on and standby
Turning the display on
After plugging the display's power cable into a wall outlet and turning on the
main power switch, the display will enter standby mode automatically. The
power indicator will light up red. Press (Power/standby) on the display.
The display will turn on and the power indicator will change to green.
Putting the display to standby
Press (Power/standby) on the display again, and the display will return to
standby mode. The power indicator will turn red.
The display still consumes a very small amount of power (about 1W) in
standby mode.
Adjusting sound
Adjusting speaker volume
• Press VOLUME  on the display to increase volume. The volume indicator
increases in length as volume rises.
• Press VOLUME  on the display to decrease volume. The volume
indicator decreases in length as volume falls.
The On-Screen Display (OSD) menu
OSD menu structure
• The available menu items are dependent on the input source being
selected. Unavailable items will be greyed out or not displayed.
• For details see "Picture menu" on page 10, "Sound menu" on page 11
and "Install menu" on page 11.
Menu
Input signal source
VGA
Picture
• Color Temp
• Brightness
• Contrast
• Auto Adjust
• Manual Adjust
• Picture Format
Sound
• Smart sound
• Virtual surround
Install
• Language
• Source List
• Factory Reset