4-11 PL17.06-A_DC
Assembly method
1. Lightly place the Front Cabinet on the set.
2. Look into the aperture to see the Front Cabinet
inlays are properly inset to the Rear Frame cut
and raised portions.
Move the Front Cabinet around (horizontally/
vertically) to see if the inlays are correctly inset. If
an inlay is correctly inset, this part of the Front
Cabinet only moves a little. If not, it moves widely.
3. Inset the inlays in the order as shown below.
Insetting in the wrong order will bend the Front
Cabinet, which results that all inlays cannot be
inset correctly.
4. Inset the inlays to the Rear Frame by applying
appropriate force to the aperture.
5. After assembling, check from the rear of the set
that the inlays are correctly inset.
Positions of Front Cabinet Inlay and
Rear Frame cut and raised portion
Correct View: the pl
ate is hidden
Front Cabinet inlay
OK
NG
Rear Frame cut and raised portions
3 3
2 2
1
Cross-section of an inlay
Inset the inlays into
the Rear Frame by apply
appropriate force
to the aperture.
Front Cabinet
Inlay
Rear Frame
Rear view of the set
OK
NG
OK
NG
2
1
To Next Page
Loading...
