▪ Press [Start] to start the software update,
make sure you have new batteries and
make sure the RC is within one meter from
the TV
▪ If a new SW update is available you will see
‘Updating’ on screen with the progress. Do
not press any key on the remote control and
don’t move the remote control. Once the
update is done you will see a message
‘Updated’. You can press [Done] to close
the wizard
▪ When no updates are found you will see a
‘No updates’ message saying that your RC is
up to date, you can close the wizard by
pressing [Done]
To Next Page
Loading...
