7-1 PL19.29-A_FW
FIRMWARE RENEWAL MODE
[TYPE A]
Equipment Required
a. USB storage device
b. Remote Control Unit
Firmware Update Procedure
User Upgrade (Filename example: : FunatvUpgrade.bin)
Upgrade the firmware only. The setting values will not be initialized.
Update procedure
1. Turn the power on.
2. Plug the AC Cord out.
3. Insert the USB storage device to the USB port as
shown below.
4. Plug the AC Cord in.
5. Software update will start automatically.
Note: Do not remove USB storage device until
software update is completely finish.
6. After finished the updating software, TV set will
automatically reboot.
7. Remove the USB storage device from the USB
port.
Rear Cabinet
USB port
USB storage
device
UPGRADING SOFTWARE
43%
PLEASE DO NOT TURN OFF
To Next Page
Loading...
