Main panel with bracket.
1. Disconnect the strain relief of the AC power cord.
2. Disconnect the degaussing coil by removing the cable from (red) connector 0201
[1].
3. Remove the panel bracket from the bottom tray, by pulling it backward [2] and
turn the chassis tray 90 degrees counter clockwise.
4. Move the panel somewhat to the left and flip it 90 degrees [3], with the
components towards the CRT.
5. Turn the panel with the rear I/O towards the CRT.
6. Place the hook of the tray in the fixation hole of the cabinet bottom [4] and secure
it.
To Next Page
Loading...
