Philips AC3033 - Quick Guide Manual

Maintenance
2
1
NanoProtect lter Series 3 (FY3430/30)
Mars DI Dach_EN
90x127mm
When display shows
When display shows
Time to clean the NanoProtect lter Series 3
Time to replace the NanoProtect
lter Series 3
Press to check lter lifetime status.
!
Press for 3 seconds to reset after cleaning or replacing lter.
3000 038 71741-1
The lter may produce smell after being used for a while because of the
absorption of indoor air. Remove the lter and place it where it has direct
sunlight and ventilation for several hours. Re-install and try using it again.
If the odor remains, please replace the lter.
Connectivity
Auto mode
Display
Control
Turbo mode Sleep mode
PM2.5
indicator
Air quality
light
Indoor allergen
index
Gas
indicator
Good Poor Very poorFair
Allergen index
1-12, 1 indicates
best air quality
Gas index
from L1-L4,
L1 indicates
best air quality
Filter cleaning
alert
Filter replacement
alert
Wi-Fi
indicator
Air Matters App
Open the app and click ‘Connect an Air Purier or Monitor ’
to connect your device. Please follow the steps in the app.
You need to connect your air purier AC3033/AC3036 with
the App to control the purier and check air quality.
Download and install
2
Power Light
on/o
Display
switch
Mode
switch
Auto
Turbo
Sleep
IAI
PM2.5
Gas
3-digit display
IAI /
Gas / PM2.5
Filter status/
reset