Philips AC4062 - Page 8


This Philips appliance complies with all standards regarding electromagnetic elds (EMF). If handled
properly and according to the instructions in this user manual, the appliance is safe to use based on
scientic evidence available today.


The appliance comes with all lters, except the zeolite gas lter, tted inside.
Tip: Place the appliance against a wall for more stability when you remove or insert lters.
Note: Make sure you insert the lters in the correct position (with the arrow facing upwards).
Note: The appliance is equipped with a safety device. If you have not placed the ESP particle lter, the
zeolite gas lter and the front panel properly, you cannot switch on the appliance.
1 Place your ngers in the recesses of the side panels. (Fig. 2)
2 Gently pull the top part of the front panel off the appliance (1) and then lift the panel
upwards to remove it (2) (Fig. 3).
3 To remove the ESP particle lter, grab the lter handles on both sides and gently slide the
lter out of the appliance. (Fig. 4)
4 Remove all packaging material from the zeolite gas lter and slide the lter into the
appliance. (Fig. 5)
, You can only insert the zeolite gas lter after you have removed the particle lter.
5 To insert the ESP particle lter, slide it into the appliance (‘click’) (Fig. 6).
6 To reattach the front panel, insert the bottom edge rst (1) and then press the top part
home (2) (Fig. 7).


1 Put the plug in the wall socket
, The standby light goes on (Fig. 8).
2 Press the function selection button one or more times to select the required function and
setting (Fig. 9).
The corresponding light goes on and the standby light goes out.
, Smart air control: the built-in air sensor determines the ambient air quality and automatically
selects the most appropriate speed. In the rst few minutes after you select the Smart air
control function, the air quality indicator ashes red to indicate that the air quality sensor is
measuring the ambient air quality. After approximately 5 minutes, the air quality indicator
lights up green if the air quality is good or lights up red if the air quality is poor (Fig. 10).
, Boost power: the appliance operates at high speed for 30 minutes (Boost power light is on)
and then automatically switches to Smart air control (Boost power light goes out and Smart
air control light goes on) (Fig. 11).
, Speed: the appliance operates at the speed you select.
- ê = low speed
- ë = medium speed
- í = high speed
3 To stop the appliance from operating, press the function selection button until the standby
light goes on (Fig. 12).
8