C
4 Clean outside of Shaver Head Assembly by
running under hot water.
5 Close the Shaver Head Assembly and
shake off excess water.
Be careful not to hit the shaving unit against
anything while shaking off excess water.
6 Open Shaver Head Assembly again and
leave open to air dry.
NOTE: Do not wipe or dry the shaving heads
with a towel or tissue. This could damage the
shaving heads.
◗ If you used foam or gel to shave, make sure to
rinse all of it off to prevent residue build-up
from clogging shaving heads.
◗ If the shaving unit becomes detached from the
shaver, you can easily reattach it.
◗ You may also clean the hair chamber without
water by using the supplied brush.
Extra-thorough Cleaning Method
Do not mix up the cutters and combs as the
shaving performance may be adversely affected
for several weeks before optimal shaving
performance is restored.
1 Turn shaver OFF, remove the charging plug
from the outlet and power cord from the
shaver.
ENGLISH
20
ENGLISH
C 2 Press the Shaver Head Release Button to
open the Shaver Head Assembly.
C 3 Pull the shaving unit off the shaver.
C 4 Turn the lock counterclockwise to unlock
(A) and remove the retaining frame (B).
C 5 Remove and clean one set of cutters and
combs at a time.
C 6 Separate the cutter from the comb and
clean it with the short bristled side of the
brush supplied.
Do not clean more than one cutter and comb
at a time, since they are all matching sets. If you
accidentally interchange the cutters and combs, it
could take several weeks before optimal shaving
performance is restored.
21
A
B
To Next Page
Loading...
