Philips CD 711 User Manual

ysi6uy
TROUBLESHOOTING
lf a fault occurs, run through the points listed below before taking your player for repair.
lf the fault remains, try to clear it by switching the player off and on again. If this also fails to help,
consult your dealer.
Under no circumstances should you repair the player yourself as this will invalidate the
guarantee!
SYMPTOM POSSIBLE CAUSE REMEDY
— The CD has been loaded e Reload the CD, label side up.
upside down.
~ No CD inserted.
— The CD is badly scratched or
dirty.
~ Moisture condensation on
the lens.
— Playback of the CD does not
start or interruption of play-
back.
insert a CD, label side up.
e Clean the CD with a soft,
lint-free cloth.
e Leave the CD player in a
warm environment unt the
moisture evaporates.
— The CD is dirty. e Clean the CD with a soft,
lint-free cloth.
— Sound skips (at the same
part).
~ The CD skips tracks. — The CD is damaged or dirty. Replace or clean the CD.
~ PROGRAM or SHUFFLE
activated.
Switch off SHUFFLE or clear
programme.
— Playback does not start from
the first track.
Check connections.
e Find another place for the
unit or change connections.
Loose or wrong connections.
Strong magnetic fields near
the CD player.
— No sound or bad sound.
Set level control
— No sound or bad sound on
headphones (CD727 only).
Level control set to — posi-
tion.
Headphones plug Is dirty.
e Clean plug.
— Remote contro! does not Batteries are empty. ¢ Replace the batteries.
function(CD721 only).
¢ Use remote control receiver
EM 2200/2201.
Reduce the distance
between remote control and
CD player.
~— The distance between
remote control and
CD player is larger than 10
metres.
— Remote control commands
are not properly received
(CD727 only).
12

Philips CD 711 Specifications

General

Type	CD Player
Channels	2
Frequency response	20Hz to 20kHz
Dynamic range	96dB
Total harmonic distortion	0.003%
Line output	2V
Digital Output	Coaxial
Power Consumption	10W
Disc format	CD
Output	Analog
Channel separation	90dB