28 EN
Remote access commands
Key Function
1 Repeat the current or listen to
the previous message.
2 Listen to messages.
3 Skip to the next message.
6 Delete the current message.
7 Switch the answering machine on.
(not available when you listen to
the messages).
8 Stop listening to the message.
9 Switch the answering machine off.
(not available when you listen to
the messages).
Behavior of the LED display on the
base station
The table below shows you the current status
with different LED display behavior on the base
station.
LED
display
Message status
Steady on
• There is no new message and
the memory is not full.
• The handset is switched on.
• Enter the paging mode
Flashing
• There is a new message and the
memory is not full.
• There is an incoming call.
• Recording an incoming mes-
sage/announcement.
• Message playback.
• Remote access/listen to mes-
sages from the handset.
Flashing
(Fast)
• There is no new message and
the memory is full.
• Enter the registration mode
To Next Page
Loading...
