Philips D230 - Blacklist Management; Change Blacklist PIN;Passcode

28 EN
Activate/deactivate the blacklist
1 Press MENU/OK.
2 Select [Privacy mode], then press MENU/
OK to conrm.
3 Enter the incoming call block PIN/
passcode. The default PIN is 0000. Then
press MENU/OK to conrm.
4 Select [Call block] > [Block mode] >
[On]/[Off], then press MENU/OK to
conrm.
» The setting is saved.
Add blacklist numbers
1 Press MENU/OK.
2 Select [Privacy mode], then press MENU/
OK to conrm.
3 Enter the incoming call block PIN/
passcode. The default PIN is 0000. Then
press MENU/OK to conrm.
4 Select [Call block] > [Block number], then
press MENU/OK to conrm.
5 Enter the number, then press MENU/OK
to conrm.
» The setting is saved.
Change the blacklist PIN/passcode
1 Press MENU/OK.
2 Select [Privacy mode], then press MENU/
OK to conrm.
3 Enter the old incoming call block PIN/
passcode. The default PIN is 0000. Then
press MENU/OK to conrm.
4 Select [Call block]> [Change PIN], then
press MENU/OK to conrm.
5 Enter the new PIN/passcode, then press
MENU/OK to conrm.
6 Enter the new PIN/passcode again, then
press MENU/OK to conrm.
» The setting is saved.