Philips D2701B/25 - Page 36

EN36
Delete all old incoming messages
From the base
Press and hold on the base station in
standby mode.
»
All old messages are permanently
deleted.
From the handset
1
Press .
2
Select [ANS.MACHINE] > [DELETE ALL
OLD], then press to conrm each
selection.
»
A conrmation request is displayed
on the handset.
3
Press to conrm or to return to
previous menu option.
»
All old messages are permanently
deleted if you press to conrm.
Note
• You can only delete the read messages.
No deleted messages can be recovered.
Set the answer delay
1
Press .
2
Select [ANS.MACHINE] > [TAM
SETTINGS] > [ANSWER DELAY], then
press to conrm each selection.
3
Select [TIME SAVER], [2 RINGS],
[4RINGS], [6 RINGS] or [8 RINGS], then
press to conrm.
»
The setting is saved.
Note
• Make sure that the answering machine
is switched on before this feature can be
applied.
Tip
• When you access the answering machine
remotely, you are recommended to
set the answer delay to [TIME SAVER]
mode. This is a cost eective way to
manage your messages. When there are
new messages, the answering machine
picks up the call after 2 rings; When
there no message, it picks up the call
after 3 rings.
Set the record time
1
Press .
2
Select [ANS.MACHINE] > [TAM
SETTINGS] > [RECORD TIME], then press
to conrm each selection.
3
Select [60 S], [120 S], [180 S] or
[UNLIMITED], then press to conrm.
»
The setting is saved.
Remote access
You can operate your answering machine
when you are away from home. Simply make
a call to your phone with a touch tone phone
and enter your 4-digit PIN code.
Note
• The remote access PIN code is the same
as your system PIN. The preset PIN is
0000.