Philips V&MA
- If the firmware upgrade files are not meant for your recorder (Check the applicable
models above
)
- Problem with writing of upgrade CD-R/CD-RW disc. Try again with a different disc.
4. Follow the on-screen instructions to complete the upgrade process.
Note: Select an on-screen button by navigating to the button using the cursor keys and pressing <OK> on
the remote control.
5. The recorder and loader firmware will be upgraded sequentially. The whole process should take about 1
minute.
6. At the end of a successful firmware upgrade, the local display of recorder will show “SW DONE”, the
dialog box on TV screen will indicate successful upgrading and the disc tray will open.
7. Remove the upgrade disc and press <OK> on the remote control.
8. The recorder will close the tray and restart automatically after about 10 seconds.
Note: Sometimes, the recorder may not close the tray automatically. Do not be alarmed. Simply press
<STANDBY> on the remote control to wake up the recorder and the tray will close immediately.
Note: You can verify the firmware upgrade by repeating
Step 1 to check the firmware version.
Important : Do not press any buttons or interrupt the mains power supply during the entire
upgrading process, otherwise the recorder may become permanently unusable!
Your product is now successfully upgraded!
To Previous Page
Loading...
