Reference : SGP_AVS_SW_ATLAS-05-05 Classification : COMPANY RESTRICTED
Version : 0.17 Project : ATLAS_DSW
Status : Proposed Chapter : User Manual
Date : 2006-09-12
Section : Diagnostic Software (Leco+)
© Philips Electronics N.V. 2006 Philips Semiconductors Page 45 of 124
1
Nucleus Name
DS_BE_MotorOff
Nucleus Number 916
Description Turn off the turntable motor by issuing a TRANSPARENT SEND and
TRANSPARENT_RECEIVE command. This nucleus is not guaranteed to work
on all connected Bes
Technical - Send the transparent BIT engine TTM command
Important note: This nucleus uses the transparent bit engine interface of the drive. It is
not guaranteed to work on all drives. Only use this nucleus if you are sure
that the drive supports this interface
Execution Time 4 seconds
User Input None
Error Number Description
91600 Turn table motor is off
91601 There was a time-out while communicating
91602 The Basic Engine returned an unexpected result
91603 The BE returned an error code
91604 No acknowledge received from BE
91605 Communicating with the Basic Engine failed
91606 Unable to enter service mode
Example
DS:> 916
091600:
Test OK @
2
Nucleus Name
DS_BE_CheckDisc
Nucleus Number 921
Description Check whether there is a disc inside the BE
Technical - Send the START_STOP_UNIT command to insert the tray
- Send the READ_TOC command
- Display the Disc type info
- If Disc type is a DVD+R(W), then read ADIP info.
- Display manufacturer and media type.
Execution Time Approximately 10 seconds
User Input None
Error Number Description
92100 There was a disc inside the set
92101 Unable to load the tray
92102 Error received from BE
Example
DS:> 921
092100:
Disc type: DVD+RW disc
Disc manufacturer id: PHILIPS
Media type id: 010
Test OK @
DS:> 921
090500:
Disc type: None
Test OK @
DS:> 921
092100:
Disc type: DVD+R disc
Disc manufacturer id: RICOHJPN
Media type id: R00
Test OK @
3
4
To Next Page
Loading...
