Finalize the disc. (The application may do this automatically.)
NOTE : Packet writing application for drag & drop copying cannot be used
for creating an upgrade disc. Use only a dedicated CD writing application
allowing ‘disc at once’ recording.
No UDF setting as well.
2. Power up the set and open tray.
3. Insert the prepared Upgrade CDROM and close the tray.
4. When the set detects a firmware image the set FTD will display:
F-UP xxxx where xxxx is the version no.
A dialogue box will appear on the TV screen for confirmation.
5. Press OK to confirm.
6. The upgrade process starts and the set FTD will display:
A-UP....
D-UP.... (Optional - only if upgrading loader firmware)
Note: Do not press any buttons or interrupt the mains supply during the
upgrading process, otherwise the set may become defective.
7. When the upgrade is successful the set FTD will display:
DONE
If the FTD display: ERROR - Proceed to step A to C
8. The tray will eject and a diaglogue box will appear on the TV screen
indicating the upgrade is done.
9. Remove the Upgrade CDROM from the tray and press Standby button to
complete the upgrading process.
To Next Page
Loading...
