Philips Electronics Singapore Software Upgrade Instruction
4 of 4
7 Steps to Upgrade Software
2. Power on the set and put in the disc.
3. A message will be displayed on the OSD after the upgrade file is recognized.
4. Follow the instruction displayed on the TV Screen – Press “OK” to upgrade (if
applicable)
5. After reading the file, the disc will be ejected
6. Remove the disc, but DO NOT close the tray
7. Wait approximately 3-5 minutes for the software to be upgraded
8. The set will restart itself once the upgrade is completed.
9.
Caution: Do not unplug or power off the set while upgrading
in progress.
8 After the upgrade
Do check the change in the Software Version to confirm the upgrade.
Please follow the procedure described in the Section 4.
To Previous Page
Loading...
